Long handbrake cable gaiter

• Primary winding resistance: 2.8 ohms
• Secondary winding resistance: 7900 ohms
• Coil compatible with electronic ignition kits Ref AVP4798 and Ref AVP4799

x1 pot of fine grain 240 lapping paste

x1 pot of coarse grain 120 lapping paste

• Special Premium Quality graphite for clutch release bearings
• Important: The release bearing clamping screw must be placed on the side opposite the fork
• It is possible to keep the release bearing and replace only the graphite ring if worn.
• Depending on the diameter of the return spring, it may be necessary to re-drill the release bearing mounting.
• It is recommended to soak the release bearing in warm engine oil and then wipe it dry before installation to avoid squeaking noises