Kit of 5 fixing clips for aluminum grille - R4 (2nd models - From 1968 to 1974) - Ref 082452800

Flexor Specifications:

• • Mounting hole spacing:4 x 50.50 mm
  • Mounting hole diameter: Ø 8.4 mm
  • Center hole diameter:Ø 10.50 mm
  • Flexor thickness: 11 mm
  • Material:Rubber flexor with metal reinforcement
  • Supplied with 4 x M8 x 20 mm screws and 4 x nylock nuts

For some assemblies with a center screw, replacing this screw with a socket head cap screw (SHCS) or modifying the flexor may be necessary.

Need x34 coins for a car

• This ignition harness consists of 4 spark plug wires and 1 coil wire, each 7mm in diameter.
• It does not have interference suppression.

If the vehicle is equipped with sensitive electronic accessories, such as a radio, trip meter, monitor, or certain electronic ignition kits, interference or disruptions may occur.

• Coil wire length: 550mm
• Spark plug wire lengths: 300mm / 300mm / 350mm / 350mm

This type of harness includes a fiberglass core supporting a conductive and magnetic silicone sheath around it around which a stainless steel wire is wound.

This winding works on the principle of a coil; an induced voltage is created by the electromagnetic flux generated by the passage of high voltage through the core of the cable.

The magnetic field fluctuates within the cable, while the stainless steel wire wound around it like a coil absorbs or compensates for the energy generated by the cable. Ignition leads equipped with an inductive resistor are wrapped with two layers of silicone and a layer of fiberglass. The internal silicone insulation ensures durability and protects against high voltages.

The fiberglass fabric increases the mechanical strength of the cable. The exterior silicone rubber insulation withstands temperatures up to 220°C and is resistant to hydrocarbons.

• Fixed by drum Ø 14mm on the wiper shafts
• Width of the arm at the point where it fits into the blade: 6mm