Intake gasket between pipe and cylinder head - 1600cm³ engine - Ref 0857720900

A110.V85

• Distance between two pulley mounting screws: 37mm
• Pulley mounting using 3 x M8 screws (Not supplied)
• The heater outlets can be plugged using two 16mm diameter rubber plugs and one 10mm diameter plug
• Water pump sold with water pump gasket, plate gasket, and plate

Fan trigger temperature 88°C

Fan stop temperature 79°C

Dimension of the axis of the upper fixing bolt at the support of the 1st washer

• The reinforced tie rod and ball joint kit (M14x150) replaces the original M12x100 tie rods and ball joints without any modification.
• It is possible to install it on an A310.4 using the AVP7609 adapter to replace the original "fork" tie rods.
• Tie rod sold individually.