Front drum brake hose (From early 1946 to early 1951) / Juvaquatre (From early to 06/194)

• Special Premium Quality graphite for clutch release bearings
• Important: The release bearing clamping screw must be placed on the side opposite the fork
• It is possible to keep the release bearing and replace only the graphite ring if worn.
• Depending on the diameter of the return spring, it may be necessary to re-drill the release bearing mounting.
• It is recommended to soak the release bearing in warm engine oil and then wipe it dry before installation to avoid squeaking noises

• This ignition harness consists of4 spark plug wires and 1 coil wire.
• We would like to point out that our spark plug wires are made with Ø 7 mm silicone wires, black in color, with a standard copper core (wire material), which indicates that they do not have interference protection.
• If the vehicle is equipped with sensitive electronic accessories, such as Radios, tripmasters, monitors, or certain electronic ignition kits may cause interference or disruption.

• Connection: Male to Male Ø 11/16"-16UNF (Ø 7.16mm)
• Length: 25.5cm (Overall)

• The hose outlet is oblique: Ø 3/8" - 24UNF(Ø 9.52mm)

Suitable for:

• 4CV: Front Left Brake (From early 1956 to late 1956)
• Dauphine / Floride : Front Right Brake
• R8 (Drum Brake): Rear Right Brake