Cylinder head inspection plate gasket - ref 0607154000

Sold without adjusting screws or handbrake lever. Caliper equipped with a square seal.

Suitable for:

• Dauphine / Dauphine Export (Disc brakes)
• R8 / Caravelle / Floride S
• A110 (Small brake setup)
• Matra Djet: Left Rear Brake Caliper

• Built-in short extensions
• Straight coil terminal
• Coil wire length: 50cm
• This ignition harness consists of 4 spark plug wires and one coil wire.
• We would like to point out that our spark plug harnesses are manufactured with 7mm diameter silicone wires, in black or red, with a standard copper core, which means they do not have interference protection.
• If the vehicle is equipped with sensitive electronic accessories, such as radios, trip masters, monitors, or certain electronic ignition kits, some interference or disruption may be observed.

Length taken from the axis of the fixing eye to the end of the rod: min adjustment 77mm / max 87mm

Segment Characteristics:

• • Segment Diameter: Ø 75.70mm
  • Thickness of Upper Segments (Fire-resistant): 1.75mm
  • Thickness of Intermediate Segments (Waterproof): 2mm
  • Low ring thickness (Scraper):4mm

It is essential to check the ring end gap of each ring before installing them on the pistons, according to the values ​​given by the manufacturer or in the supplied instructions.or the values ​​provided in the instruction manual.

During installation, the ring end gap must be evenly distributed around the piston circumference at 120°.

• Kit to be used with a coil of primary resistance between 2.5 and 3.5 ohms
• Compatible with coils AVP4708 and AVP4715
• Compatible for Ducellier igniter with an inner body diameter of Ø 58.8mm
• Not suitable for an igniter with externally adjusted breakers (different plate fixing points)
• 12V electronic ignition kit , with magnetic trigger which allows the elimination of the breakers and the capacitor
• Notice included
• Supplied with 3 screws for fixing the plate
• Instructions included