Cardboard air duct Ø 60mm - Extensible from 0.50cm to 1m

• Mounting diameter of the head on the igniter: Ø 64.5mm

Braided stainless steel hose (aviation-style) connecting the master and slave cylinders; ideal for replacing the original plastic hose.

Offers superior resistance to abrasion, heat, and temperature fluctuations.

Direct replacement for the original part; no modifications required.

• Supplied with 2 banjo bolts (M12x1.00) and 4 copper washers.
• Hose length (measured center-to-center between banjo fittings): 285.5 cm

Compatible with the following vehicles:

• A310.4: From chassis no. 635 through the end of production (with 2nd-generation clutch slave cylinder).
• A310 V6: All models (pre- and post-1980).

• Useful length (L on photo diagram number 3): 12.5mm
• Sold with the pin
• OE Renault / Alpine Ref: 0705339100

• Distance between two pulley mounting screws: 30mm
• Pulley is secured using 3 M7 screws (not supplied)
• The heater outlets can be plugged using two 16mm diameter rubber plugs and one 10mm diameter plug
• Water pump sold with water pump gasket, plate gasket, bleed plate, and bleed screw

• This kit contains an M9 adjustment screw nut and an M8 nut
• To identify a caliper with a square or round joint, refer to the symbol indicated on the caliper casting.
• A square symbol indicates a square joint, while a circle symbol indicates a round joint.
• It is essential to preserve and replace the joint that originally came with the caliper.
• We recommend checking the symbol displayed on each caliper, as a vehicle may have calipers from different origins, some with square joints and others with round joints.
• It is not recommended to mix calipers on the same axle, as this can lead to the risk of them slipping during braking.