Accelerator Control Ball Joint - Ø10 Ball / M6 Rod (Right Hand Thread)

• This ignition harness consists of4 spark plug wires and1 coil wire.
• We would like to point out that our spark plug wires are made with 7 mm diameter silicone wires, black with a standard copper core (wire material), which indicates that they do not have interference protection.
• If the vehicle is equipped with sensitive electronic accessories such as a radio, tripmaster, monitor, or certain ignition kits electronic equipment, interference or disruption may occur.

• Special Premium Quality graphite for clutch release bearings
• Important: The release bearing clamping screw must be placed on the side opposite the fork
• Depending on the diameter of the return spring, it may be necessary to re-drill the release bearing mounting.
• It is recommended to soak the release bearing in warm engine oil and then wipe it dry before installation to avoid squeaking noises

Suitable for:

• R4 /4L : Front Brake
• R5 : Front Brake
• R5 Alpine Atmo (1223) and Alpine Turbo (122B): Front Brake
• R8: Big Brake Installation Front Brake
• R12 (All models) : Front Brake
• R15 / R16 / R17 (All models): Front Brake
• A110 : Big Brake Installation Front Brake
• A310.4 / A310 V6 (Pre-1980) : Front Brake

Brake pads with a retaining stop (B in the diagram) must be installed with this stop positioned towards front (direction of wheel rotation)

Suitable for:

• R5 Alpine (R1223)
• R5 Alpine Turbo (R122B)