warning switch

• Fuel pressure gauge kit.
• Allows fuel pressure adjustment with the "King" filter REF 6825.
• Graduation from 0.20g up to 1 bar.
• With connector and clamp for 6 or 8 diameter flexible hoses.
• The pressure gauge can be removed after adjustment and the cap provided in the kit can be screwed on for greater privacy in the engine compartment.

Braided stainless steel hose (aviation-style) connecting the master and slave cylinders; ideal for replacing the original plastic hose.

Offers superior resistance to abrasion, heat, and temperature fluctuations.

Direct replacement for the original part; no modifications required.

• Supplied with 2 banjo bolts (M12x1.00) and 4 copper washers.
• Hose length (measured center-to-center between banjo fittings): 285.5 cm

Compatible with the following vehicles:

• A310.4: From chassis no. 635 through the end of production (with 2nd-generation clutch slave cylinder).
• A310 V6: All models (pre- and post-1980).

• This kit contains an M9 adjustment screw nut and an M8 nut.
• Kit sold with a strong Ø 38mm square gasket and a weak Ø 38mm gasket.
• The supply of these two seals allows you to install the most suitable seal depending on the wear of the caliper grooves.
• To identify a caliper with a square or round seal, refer to the symbol indicated on the caliper casting.
• A square symbol indicates a square seal, while a circle symbol indicates a round seal.
• It is essential to replace the same type of seal (round or square) according to the symbol on the caliper.
• We recommend checking the symbol displayed on each caliper, as a vehicle may have Calipers of different origins, some of which may have square joints and others round joints.
• It is not recommended to mix calipers on the same set, as this can lead to the risk of skewing during braking.