Upper/lower ball joint "adaptable" rubber dust cover - large model

• • ATTENTION: straight, non-offset bracket for mounting a Bendix-type "big brake" caliper bracket
  • Brake bracket mounting hole spacing: 100mm
  • Original Alpine part number: 6000001437
  • Fixing with AVP4300 screws
  • ATTENTION, suitable for:

-Big brake setup identical to the original: 10mm thick rear brake disc (12mm - 2mm on the inner face) + Bendix R16 bracket with 100mm mounting hole spacing + original single-row wheel bearing + original hub

or

-Big brake setup with: Big bearing kit REF AVP6413 + 12mm rear brake disc REF AVP4444 + Bendix R16 bracket with 100mm mounting hole spacing

It is essential, in all cases, to check the centering of the brake disc in the Bendix bracket.

For mounting with Ø15mm control shafts

This repair kit is suitable for remanufactured clutch slaves (AVP9115 or ref AVP9131)

Fan trigger temperature 82°C

Fan stop temperature 72°C

• This kit contains an M9 adjustment screw nut and an M8 nut
• To identify a caliper with a square or round joint, refer to the symbol indicated on the caliper casting.
• A square symbol indicates a square joint, while a circle symbol indicates a round joint.
• It is essential to preserve and replace the joint that originally came with the caliper.
• We recommend checking the symbol displayed on each caliper, as a vehicle may have calipers from different origins, some with square joints and others with round joints.
• It is not recommended to mix calipers on the same axle, as this can lead to the risk of them slipping during braking.