Rear light seal - R4L Saloon

• Special Premium Quality graphite for clutch release bearings
• Important: The release bearing clamping screw must be placed on the side opposite the fork
• It is possible to keep the release bearing and replace only the graphite ring if worn.
• Depending on the diameter of the return spring, it may be necessary to re-drill the release bearing mounting.
• It is recommended to soak the release bearing in warm engine oil and then wipe it dry before installation to avoid squeaking noises

Caliper equipped with square joint.

Fit on:

• Dauphine (Disc brakes)
• R8 / Caravelle / Floride S
• A110 (Small brakes mounting)

Cap Dimensions:

• Inner Diameter: Ø 47mm
• Outer Diameter: Ø 49.5mm
• Height: 23mm

REF: 7700760909