Long rear shock absorber mounting bolt Ø9 - ref 0608388600

Suitable for:

• Dauphine (R1090 / R1091)
• Floride
• Alpine A108 (To be cut)

• Overall length: 198.5cm
• Sheath length: 67cm x 2
• Cable length: 196cm

Our cables are made in France and meet the assembly and quality standards of original equipment (OEM) cables from automotive manufacturers.

Sold without adjusting screws or handbrake lever. Caliper equipped with a square seal.

Suitable for:

• Dauphine / Dauphine Export (Disc brakes)
• R8 / Caravelle / Floride S
• A110 (Small brake setup)
• Matra Djet: Left Rear Brake Caliper

The kit contains:

• 4 x 8mm smooth-bore screws - M8 thread (to be positioned on the wheel side)
• 4 x 8.4mm smooth-bore screws - M8 thread (to be positioned on the body or chassis side)

Alpine / Renault OE Ref: 0706289800 / 0706290200

A kit is required to equip both front wishbones of a car

• This kit contains an M9 adjustment screw nut and an M8 nut.
• Kit sold with a strong Ø 38mm square gasket and a weak Ø 38mm gasket.
• The supply of these two seals allows you to install the most suitable seal depending on the wear of the caliper grooves.
• To identify a caliper with a square or round seal, refer to the symbol indicated on the caliper casting.
• A square symbol indicates a square seal, while a circle symbol indicates a round seal.
• It is essential to replace the same type of seal (round or square) according to the symbol on the caliper.
• We recommend checking the symbol displayed on each caliper, as a vehicle may have Calipers of different origins, some of which may have square joints and others round joints.
• It is not recommended to mix calipers on the same set, as this can lead to the risk of skewing during braking.