Kit of 4 rubber seals under exterior door handle

• This ignition harness consists of 4 spark plug wires and one coil wire.
• Terminals on coil 90° angled
• Length of coil cable: 61cm
• Length of 2 spark plug wires: 26.5cm
• Length of 2 spark plug wires: 36.5cm
• We would like to point out that our spark plug harnesses are manufactured with 7mm diameter silicone wires, in black or red, with a standard copper core, which indicates that they do not have interference protection.
• If the car is equipped with sensitive electronic accessories, such as radios, Trip Master, Monitors, or certain electronic ignition kits, some interference or disruption may be observed.

• Kit sold individually

Please note this hose cannot replace the original oil hoses, use only to carry out an adaptable assembly using a connector and a new radiator.

Material: Black synthetic braid

Maximum operating pressure 35 bar and burst pressure 138 bar

• This kit contains an M9 adjustment screw nut and an M8 nut.
• Kit sold with a strong Ø 38mm square gasket and a weak Ø 38mm gasket.
• The supply of these two seals allows you to install the most suitable seal depending on the wear of the caliper grooves.
• To identify a caliper with a square or round seal, refer to the symbol indicated on the caliper casting.
• A square symbol indicates a square seal, while a circle symbol indicates a round seal.
• It is essential to replace the same type of seal (round or square) according to the symbol on the caliper.
• We recommend checking the symbol displayed on each caliper, as a vehicle may have Calipers of different origins, some of which may have square joints and others round joints.
• It is not recommended to mix calipers on the same set, as this can lead to the risk of skewing during braking.