Ducellier distributor head retaining clip kit

• Cooling fan: Pusher or Puller
• Universal Spal connector (requires modification depending on specific vehicle wiring)
• Observe correct wiring polarity for fan rotation:
• Fan in puller mode: Red (+ Battery) / Black (- / Ground)
• Fan in pusher mode: Red (- / Ground) / Black (+ Battery)
• Fan supplied as a standalone unit; mounting or fixing kit not included.
• See fan dimensions in photo #2

Ideal for securing:

• Headlining
• Interior trim, carpets, rugs, ...
• Rubber mats

The sets are supplied with the following components:

• Liners (x4)
• Pistons (x4)
• Rings (x12)
• Pin (x4)
• Circle clips (x8)

Dimensions of the different parts:

• • Liner bore diameter: Ø 58mm
  • Liner flange or top diameter (D): Ø 73mm
  • Liner base diameter (A): Ø 62.50mm
  • Overall height including skirts of the sleeves (C): 126mm
  • Height from the top of the sleeve to the base gasket area (E): 112.80mm
  • Shaft dimensions: Ø 14x50mm (Mounting with circlips)
  • Segment thickness: 1.75mm / 2mm / 3.5mm (Fireproof/Sealing/Scraper)
  • Base gasket type: Copper gasket

Caution:It is probable Modern cylinder liners and pistons are equipped with a shorter skirt. Installing modern cylinder liners and pistons to replace the original kits requires no modifications.

A shorter skirt promotes better lubrication and allows for an increased crankshaft stroke to prevent the skirt from contacting the connecting rod.

Piston installation direction: An arrow drawn perpendicular to the piston axis is marked on the top of the piston. It must be oriented in the direction of engine rotation during the connecting rod's downward stroke (see manufacturer's instructions or diagram). It is essential to check the ring end gap of each piston ring before installing them on the pistons, according to the values ​​given by the manufacturer or in the supplied instructions. During installation, the ring end gap must be evenly distributed around the piston circumference at 120° intervals.

The oil filter sandwich plate fits between the oil filter and the engine block.

It offers improved oil flow thanks to wider, unrestricted internal channels, making it ideal for installing an additional oil cooler.

• Inlet and outlet ports (female):1/2" x 14 BSP (x2)
• Oil filter threaded adapter diameter:Male Ø 3/4"-16 UNF and female Ø 3/4"-16 UNF
• Two female ports: 1/8-27 NPT (for mounting oil pressure and temperature sensors)

Please note: this oil filter plate is not compatible with OEM hoses and fittings. You will need to replace these fittings and hoses.