Center silent block stabilizer bar support

Carburetor needle 1.5

Sold without adjusting screws or handbrake lever. Caliper equipped with a square seal.

Suitable for:

• Dauphine / Dauphine Export (Disc brakes)
• R8 / Caravelle / Floride S
• A110 (Small brake setup)
• Matra Djet: Right Rear Brake Caliper

Suitable for:

• R8 / R8G / A110 : Front or rear disc (Big brake assembly)
• A110 1600 SX (VH) : Front or rear disc 
• R16 (L / TL / TS) / R16TX : Front disc
• A310.4 (No. 910 at the end of the series): Front disc
• A310 V6 - Before 1980 (No. 1 to No. 47708 ): Rear disc

Réf OE Renault : 0428906000 / 7700572631

• This kit contains an M9 adjustment screw nut and an M8 nut
• To identify a caliper with a square or round seal, refer to the symbol indicated on the caliper casting.
• A square symbol indicates a square seal, while a circle symbol indicates a round seal.
• It is essential to replace the same seal type (round or square) according to the symbol on the caliper.
• We recommend checking the symbol displayed on each caliper, as a vehicle may have calipers from different manufacturers, some with square seals and others with round seals. round.
• It is not recommended to mix calipers on the same set, as this can lead to the risk of calipers slipping when braking.

Not suitable for replacing the original ball joint bellows

Plug specifications:

• Outer diameter: Ø 77.50mm
• Mounting diameter: Ø 63mm
• Plug height: 9mm
• Material: Rubber
• Renault OE Ref.: 6051676 / 0605167600

Suitable for:

• Dauphine: Front luggage compartment floor or cabin floor plug
• Floride / Caravelle: Front luggage compartment floor or cabin floor plug
• R8 / R8G: Front luggage compartment floor or radiator panel plug
• R4 (all models): Engine bay inner wing plug