Aluminum flat gasket Ø 22x28x1.5

To turn on a temperature warning light

Trigger temperature 97°C

ATTENTION: Suitable for mounting "small" original brakes with original caliper and brake disc

Kit for mounting large wheel bearings on the rear axle, including:

• 2 Bearing carriers machined from 42CrMo4 hardened and burnished steel,
• 2 Double-row bearings with high-temperature resistant polyamide cages (which prevents seizing in case of cage damage), with a double water-resistant seal (the axle grease fitting can be removed as the bearing is sealed),
• 2 10-spline hubs with 10.9 wheel studs,
• 6 Studs with reinforced brake nuts (gluing the studs is recommended for installation in the bearing housings).
• 2 M20 x 150 rear hub castellated nuts
• 2 Ø 20mm rear hub conical washers

2 cotter pins

Eliminates wheel play and improves axle guidance.

Improves differential oil seal sealing.

Improves geometry and handling precision.

Ready to be mounted on the original axle housing without modification.

CAUTION: It is recommended to check the axle alignment and the centering of the brake disc relative to the brake caliper bracket/clamp.

• Need 1 AVP6816 gasket and 3 AVP6815 gaskets to equip an engine

• Air intake trumpet/trumpet filters for WEBER 45DCOE carburetor
• Mesh filters made of two layers of stainless steel mesh, with an intermediate filter layer ensuring optimal engine protection
• Easily washable and removable
• Suitable for trumpets with an outer flange diameter between Ø 60mm and 70mm
• Filter inner diameter: Ø 58mm
• Filter outer diameter: Ø 80mm
• The filter length when installed on a 63mm trumpet is 82mm (overall)
• Can be mounted on the entire assembly cones from the AVP catalog

• Center distance between carburetor and intake pipe : 110mm and 70mm
• Flanges with tapping for a vacuum
• Flanges to be assembled directly on the carburetors, the seal is ensured by O-rings (delivered with 4 O-rings)