"Alpine Renault" crest

• Special Premium Quality graphite for clutch release bearings
• Important: The release bearing clamping screw must be placed on the side opposite the fork
• It is possible to keep the release bearing and replace only the graphite ring if worn.
• Depending on the diameter of the return spring, it may be necessary to re-drill the release bearing mounting.
• It is recommended to soak the release bearing in warm engine oil and then wipe it dry before installation to avoid squeaking noises

Sheets (x4)

Sheet Dimensions:

• Sheet Bore Diameter: Ø 59.95mm
• Sheet Flange or Top Diameter (D): Ø 72.75mm
• Sheet Base Diameter (A): Ø 62.40mm
• Sheet Height (including skirts, overall) (C): 121mm
• Sheet Height to Base Seals (E): 112mm
• Base gasket type: Copper gasket

• Diameter: 7cm